Event Timers - American Dynamics MegaPower 3200 Administrator's Manual

The Add Contacts dialog provides three options.
1. To select an option, click the button beside the
option, and complete the required information.
Options are:
• Replace with the following sequence –
enter a range of monitors, for example, 1-256.
• Add a single Contact – Click the up or down
arrows to select a contact.
• Add a range of Contacts – Click the up or
down arrows on the "from" and "to" fields to
select a range of contacts.
2. Click OK to save your contact choices or Cancel
to close the dialog box without saving your
choices.
Deleting Contacts
To delete contacts assigned to a monitor defined in
the Contact Arming tab, do the following:
1. In the upper screen, click on the monitor that
contains the contact(s) to be deleted.
2. Click on the contact(s) in the lower screen to be
deleted, and then click Remove on the right side
of the screen.

Event Timers

The Event Timers tab allows you to view or delete
event timer information that is associated with
selected monitors.
Note: Event timers displayed in this screen are for
information only, and they cannot be added or edited
here, but they can be deleted. You must define event
timers in the Switching – Event Timer screen as
described on page 27.
Viewing Event Timers
To view event timer information from the Partitions –
Monitors to Cameras screen:
1. Click on a monitor in the upper screen.
2. Click the Event Timers tab in the lower screen.
Figure 124. Event timers screen
MEGAPOWER CPU
ADMINISTRATOR'S GUIDE
Deleting Event Timers
To delete an event timer definition:
1. Click on a monitor in the upper screen.
2. Left click the left header of the row in the lower
screen that contains the event timer definition to
be deleted.
3. Press the keyboard Delete key of the PC running
EASY CPU. The Delete Rows dialog box
appears.
Figure 125. Delete Rows dialog
4. Click Yes to delete the event timer definition or
No to close the dialog box without deleting the
definition.
53 of 72
8200-0421-03, REV. D