Event Timers; Creating Alarm Monitor/Contact Tables - American Dynamics MegaPower 3200 Administrator's Manual

Figure 69. Add Contacts dialog
The Add Contacts dialog provides three options.
1. To select an option, click the button beside the
option, and complete the required information.
Options are:
− Replace with the following sequence – enter
a range of monitors, for example, 1-256.
− Add a single Contact – Click the up or down
arrows to select a contact.
− Add a range of Contacts – Click the up or
down arrows on the "from" and "to" fields to
select a range of contacts.
2. Click OK to save your contact choices or Cancel
to close the dialog box without saving your
choices.
Deleting Contacts
To delete contacts assigned to a monitor as defined
in the Contact Arming tab, do the following:
1. In the upper screen, click on the monitor that
contains the contact(s) to be deleted.
2. Click on the contact(s) in the lower screen to be
deleted, and then press Remove on the right side
of the screen.

Event Timers

The Event Timers tab in the Alarms – Monitor screen
allows you to view and delete event timer information
that is associated with selected monitors.
Note: Event timers displayed in this screen are for
information only, and they cannot be added or edited
here. You must define event timers in the Switching –
Event Timer screen as described on page 27.
MEGAPOWER CPU
ADMINISTRATOR'S GUIDE
Viewing Event Timers
To view event timer information from the Alarms –
Monitor screen:
1. Click on a monitor in the upper screen.
2. Click the Event Timers tab on the Alarms –
Monitor screen.
Figure 70. Event timers screen
Deleting Event Timers
To delete an event timer definition:
1. Click on a monitor in the upper screen.
2. Left click the left header of the row in the lower
screen that contains the event timer definition to
be deleted.
3. Press the keyboard Delete key of the PC running
EASY CPU. The Delete Rows dialog box
appears.
Figure 71. Delete Rows dialog
4. Click Yes to delete the event timer definition or
No to close the dialog box without deleting the
definition.
Creating Alarm
Monitor/Contact Tables
Alarm Monitor/Contact Tables allow you to associate
alarm contacts with cameras or Salvos, Presets, and
auxiliaries. You can set the alarm dwell time,
auxiliary states, connections, and the locations of
each alarm contact.
Click on Alarms – Contact Definitions to begin. The
following screen appears (Figure 72 on page 32).
31 of 72
8200-0421-03, REV. D