Adding A User Login - American Dynamics MegaPower 3200 Administrator's Manual

7. In the MPCPU Address field, enter the IP address
of the desired MegaPower CPU, or select one
from the dropdown list.
8. Click OK to begin writing the configuration data
into the CPU, or Cancel to close the dialog box
without writing the configuration data.
9. Choose one of the following:
• If you want to enable user logins, go to the
section, Adding a User Login, on this page.
• If you do not want to enable user logins, your
system is ready to use.
New Configuration File
Note: You must save a new configuration file to your
PC before EASY CPU allows you to write to the
MegaPower CPU.
To create a new configuration file, do the following:
1. Click File on the main screen.
2. Click New in the dropdown menu bar.
3. Using the configuring information throughout this
guide, set up your system configuration.
4. When you have completed your configuration,
click File on the main screen.
5. Click Save in the dropdown menu bar.
6. Navigate through the Save dialog box to a desired
folder, and enter an appropriate file name for your
configuration.
7. Click Save to save the file. The file is saved to
your PC.
8. Click File on the main screen.
9. Click Write in the dropdown menu bar. The
Choose Address dialog box appears.
Figure 42. Choose Address dialog
10. In the MPCPU Address field, enter the IP address
of the desired MegaPower CPU, or select one
from the dropdown list.
MEGAPOWER CPU
ADMINISTRATOR'S GUIDE
11. Click OK to begin writing the configuration data
into the CPU, or Cancel to close the dialog box
without writing the configuration data.
12. Choose one of the following:
• If you want to enable user logins, go to the
section, Adding a User Login, below.
• If you do not want to enable user logins, your
system is ready to use.

Adding a User Login

When you create a user login, the CPU login request
function is enabled. Users must log in to be able to
read and write configuration data.
To create a user login:
1. With EASY CPU started and a configuration file
open, click Edit in the dropdown menu bar.
2. Click User Logins.... The EASY CPU – Login
Manager dialog box appears.
Figure 43. Login Manager dialog
3. Click New User.... The Login Properties dialog
box appears (Figure 44 on page 18).
17 of 72
8200-0421-03, REV. D