Adjusting Camera V-Phase
Use of this utility should be limited to authorized service personnel. To
adjust the V-phase of a selected camera, do the following:
1. Press Menu.
2. Using the Tracker Ball, scroll down to Adjust V-Phase.
3. Press the Zoom or Focus button to select the Adjust V-Phase
menu option.
4. Press Next or Previous to observe the V-Phase through the
oscilloscope or Fluke scope.
5. Press Menu to exit.
I M P O R T A N T
Off-line domes or fixed cameras will generate a warning beep and disallow
use of the V-Phase utility. For additional information on adjusting the V-
Phase, see the service section of the AD Touch Tracker 16 manual.
Special Utilities
Although Show Sys Info and Ping Dome/TTR are considered utility
items on the menu, these utilities are reserved for use by authorized service
personnel. However, you may also perform these tasks in conjunction with
an authorized service provider over the phone. There are no procedures in
this documentation describing their use.
TOUCH TRACKER Utilities
5-11