Clearing System Alarms - American Dynamics ADTT16 Operator's Manual

output off). The List of Inputs and Outputs provides the on and off states
for each output.
Depending on whether you turned the output on or off in the previous
step, the LCD displays one of the following messages:
If you entered an invalid output number (any number greater than 4 or an
output that does not exist) the T

Clearing System Alarms

Tip: Alarms can be cleared from the Main T
Your system can be configured to handle up to 64 different alarms. When an
alarm is triggered, it takes precedence over whatever you are doing on the
Main monitor and Main T
are in the programming mode when an alarm comes in, the alarm information
replaces the programming information on the LCD. If you are running the
Sequence when an alarm comes in, the alarm information will replace the
Sequence information on the LCD. In addition, the video information for the
alarm will replace the video information from the Sequence on the Main
monitor.
The Call monitor and Call T
alarms.
Each alarm can be configured to automatically call up video and initiate an
output. For example, when an alarm is triggered, it can automatically run a
specific Pattern and set off an audible alarm. In addition, whenever an alarm
is triggered, the T
T
OUCH
cleared.
3-12
Cam 13
Output On
OUCH
T
OUCH RACKER
T will continue to beep intermittently until the alarm is
RACKER
Cam 13
-or-
Output Off
T
OUCH RACKER
OUCH
T at the time. For example, if you
RACKER
T remain unaffected by incoming
OUCH RACKER
will beep, signaling an active alarm. The
beeps.
T only.
RACKER
Operator's Manual