Defining A Quick View - American Dynamics ADTT16 Operator's Manual

Defining a Quick View

I M P O R T A N T
The SpeedDome Ultra III and newer domes support up to 96 views. Older
programmable domes support up to 4 views. The T
when you attempt to program a view numbered higher than 4 on domes older
than the SpeedDome Ultra III.
A Quick View automatically and instantaneously calls up a view from a
programmable dome, regardless of where that dome is currently pointing.
You can define your own Quick Views to support your specific needs.
Depending on the type of dome, either 4 or 96 views may be defined.
Tip: You must use the Main T
If you make a mistake during programming or you no longer want to
program the Quick View, press the Menu or the Clear button at any time to
cancel programming. The T
mode.
The following procedure describes how to define a Quick View.
1. Using the number buttons, enter the number of the programmable camera
for which you are defining this Quick View (for example, camera 7).
Then press the Camera button.
2. Pan and tilt the camera so that it is pointing at the view you want to
define. Then zoom and focus the camera accordingly.
3. When you have the perfect picture displayed on the monitor, press the
Menu button.
4-2
T to define Quick Views.
OUCH RACKER
T returns to the camera control
OUCH RACKER
T beeps
OUCH RACKER
Operator's Manual