American Dynamics ADTT16 Operator's Manual page 45

The T
menu appears:
4. Use the Tracker Ball to scroll through the menu selections until Setup
View is displayed on the LCD.
5. Press the appropriate button, zoom or focus, to select Setup View.
The following prompt appears on the LCD:
If you press a number that has already been assigned to a Quick View for
Note
this camera, the new Quick View will overwrite the existing Quick View.
There is no warning to indicate that the existing Quick View will be
replaced. Use caution.
6. Press the number on the keypad (1 - 96) that you want to assign to this
Quick View, then press Zoom or Focus.
The following message appears briefly on the LCD:
If you press an invalid number (any number greater than 96), the T
T
RACKER
happens, simply press a valid number and the Quick View will be saved.
The T
Defining Automatic System Functions
T
OUCH RACKER
beeps, and the system will not save the Quick View. If this
T automatically returns to the camera control mode.
OUCH RACKER
is now in the menu/programming mode, and the
Calibration
Define Sequence
Setup View
Record Pattern
Cam 7
Enter View#?
Cam 7
View Saved
OUCH
4-3