American Dynamics ADTT16 Operator's Manual page 47

Tip: You must use the Main T
The SpeedDome LT does not support Pattern programming. Refer to the
section in this chapter titled "SpeedDome LT Auto Pan Programming" for
information about setting the Auto Pan feature.
The following procedure describes how to define a Pattern.
1. Using the number buttons, enter the number of the programmable camera
for which you are defining the Pattern (for example, camera 3). Then
press the Camera button.
2. Pan and tilt the camera to the starting point of the Pattern, and then zoom
and focus the camera accordingly.
3. When you have the perfect "starting point" picture displayed on the
monitor, press the Menu button.
The T
menu appears:
Defining Automatic System Functions
T is now in the menu/programming mode, and the
OUCH RACKER
Calibration
Define Sequence
T to define Patterns.
OUCH RACKER
4-5