Displaying Quick Views - American Dynamics ADTT16 Operator's Manual

The following procedure describes how to initiate the Apple Peel pattern.
1. Use the number buttons to enter the number of the SpeedDome for which
you want to initiate the Apple Peel pattern (for example, camera 2). Then
press the Camera button.
2. Press the Peel button.
The LCD displays the following message:
The Apple Peel pattern will repeat itself indefinitely until you issue a camera
command (pan, tilt, zoom, focus, or iris) to the dome running the pattern.

Displaying Quick Views

I M P O R T A N T
The SpeedDome Ultra III and newer domes support up to 96 views. Older
domes support up to 4 views. The T
to call up a view numbered higher than 4 on domes older than the
SpeedDome Ultra III.
A Quick View enables you to instantaneously call up a specific view from a
programmable dome, regardless of where that dome is currently pointing. A
Quick View is useful when you want to look at a particular item or area
immediately. You may not want to manually pan and tilt the camera to the
specific area, and then zoom and focus.
You can define your own Quick Views to support your specific needs. Refer
to Chapter 4, "Defining Automatic System Functions," for procedures on
defining Quick Views.
3-6
Cam 2
Apple Peel Patn
T
OUCH RACKER
beeps when you attempt
Operator's Manual