Sequencing Mode - American Dynamics ADTT16 Operator's Manual

In the menu/programming mode, you can perform the following activities:
Program the Quick Views for each programmable dome. (Refer to
"Defining Quick Views," in Chapter 4.)
Program the Patterns for each programmable dome. (Refer to "Defining
Patterns," in Chapter 4.)
Assign the Quick Views, Patterns, and fixed shots to be included in the
Sequence. (Refer to "Defining the Sequence" in Chapter 4.)
Define which inputs will trigger an alarm, and what camera action and/or
output initiates when that alarm is triggered. (Refer to "Defining Dome
Alarms," in Chapter 4.)
Indicate which external device your system is connected to: a quad
splitter, a 4-camera multiplexer, a 9-camera multiplexer, a 16-camera
multiplexer, a PC, or no unit. (Refer to "Designating Which Type of Unit
You Are Connected to," in Chapter 2.)
Tune the Tracker Ball sensor for maximum range of motion. (Refer to
"Calibrating the Tracker Ball," in Chapter 5.)
Reset a SpeedDome if it is not responding as expected to T
T
Select from 10 different languages in which to display the LCD text.
(Refer to "Selecting a Language," in Chapter 5.)
Assign the Main and Call T
Main Versus Call T
Swap the functionality of the zoom and focus buttons. (Refer to
"Swapping the Zoom and Focus Buttons," in Chapter 5.)

Sequencing Mode

You activate the sequencing mode by pressing the Seq button; this initiates
the Sequence you defined in the menu/programming mode.
The Sequence consists of up to 16 of the previously defined Quick Views
and Patterns (called events). These events run one after the other on the
About AD T T
OUCH RACKER
commands. (Refer to "Resetting a Dome," in Chapter 5.)
RACKER
OUCH
16
T s. (Refer to "Designating
OUCH RACKER
T ," in Chapter 5.)
RACKER
OUCH
1-11