American Dynamics ADTT16 Operator's Manual page 37

2. Use the number buttons to enter the number of the Pattern you want to
run. Then press the Pattern button (if you want the Pattern to run one
time and then stop), or press the Repeat Pattern button (if you want
the Pattern to repeat indefinitely until you stop it).
If that Pattern exists for that camera, the Pattern will automatically begin
running. If that Pattern does not exist for that camera, the camera will
run the default Apple Peel pattern.
Depending on whether this is a Pattern that will run once or a repeating
Pattern, one of the following messages appears on the LCD:
Cam 8
Cam 8
-or-
Repeat Pattern
Run Pattern
If you instructed the Pattern to run through one time, the following
message appears on the LCD once the Pattern is complete:
Cam 8
Pattern Done
If you instructed the Pattern to repeat itself, the Pattern will continue
running until you manually issue a camera command (pan, tilt, zoom,
focus, or iris) to the dome running the Pattern.
If you tried to run a Pattern for a non-programmable dome, or if you
entered an invalid Pattern number (any number greater than 3), the
T T beeps.
OUCH RACKER
Controlling Cameras and Their Outputs 3-9