Displaying A Dome's Id Code - American Dynamics ADTT16 Operator's Manual

Displaying a Dome's ID Code

The following procedure describes how to display the ID code for the
currently selected dome. The ID code may be useful when diagnosing a
problem.
1. Using the number buttons, enter the number of the dome whose ID code
you want to display (for example, camera 3) and then press the Camera
button.
2. Press the Info button on the keypad.
The LCD displays the following prompt:
Notice the "F" prefix in front of the ID code; this indicates that it applies
to the dome's Flash PROM.
3. Press the Info button again to display the dome's EEPROM ID code.
Notice the "E" prefix in front of the ID code; this indicates that it applies
to the dome's EEPROM.
4. Each time you press the Info button, you alternate between the Flash
PROM and the EEPROM ID codes.
5. Press the Clear button to refresh the LCD.
The T
5-10
T is again in the camera control mode.
OUCH RACKER
Cam 3
F 0701-0081-0134
Cam 3
E 0701-0079-0310
Operator's Manual