Sony KF-E42A10 Service Manual page 54

LOWER MAIN HARNESS INSTALLATION (2 OF 3)
5
Install 11mm purselock just below M3 Clamp as shown on
picture. Reason for purslelock is to keep wires together.
Wires need to be controlled to prevent pinch points when
B-Block is installed.
11mm purselock p/n:4-049-281-01
7
CAUTION: Make sure Upper Harness Cable is NOT
routed in FRONT of the Duct Cover. This causes
Pinch Point when B-Block is installed and can
damage cables.
KF-E42A10/E50A10
6
Route all cables through the "C" cut-out in the duct cover. The 11mm
purselock should be BEHIND the "C" cut-out in black plastic duct cover.
8
CAUTION: Route Upper Harness cables on the SIDE of
the duct cover. Keep cables away from FRONT of
the duct cover. ALL cables must not be routed in the
front of the duct cover because of pinch points
created when B-Block is installed.
KF-E42A10/E50A10
Tool / Torque
-Phillips Screw Driver
-[3x12mm]
- 7kg-cm +-1.0kg-cm
Caution Points
Please Follow All
CAUTION points listed. It
is important to control
VARIATION of wire
routing for minimizing
Electro Maagnetic
Interference (EMI)
54