Sony KF-E42A10 Service Manual page 35

B BLOCK ASSEMBLY INSTALLATION (4 OF 5)
12
Connect B-Block Fan connector to CN8002 Pig-tail connector
on the AGA -Bd.
CAUTION: Fan joint-connector is positioned in the middle
Between B-Block metal box and AGA-Bd.
14
Install Grounding strap (p/n:1-910-015-33) to top-right Metal Tab.
CAUTION: Make sure terminal is "locked" in place after installation.
KF-E42A10/E50A10
13
Another view of left side of B-Block cable dressing.
CAUTION:
-Note "DOT" on LVDS Connector. Do not try to insert connector reversed.
-Note orientation of ferrite core – vertical
-Wires on 11P Conn. Assy. Are routed along
the metal shield case.
-Note 11P cable is looped and held by
M4 Clamp (one loop around wires).
CAUTION 2:
Keep looped wire away from edge of bottom
Cabinet and screw boss pocket. This is a pinch
point that can damage the wires when rear
cover is installed.
KF-E42A10/E50A10
Tool / Torque
Caution Points
Please Follow All
CAUTION points listed. It
is important to control
VARIATION of wire
routing for minimizing
Electro Maagnetic
Interference (EMI)
35