Sony KF-E42A10 Service Manual page 13

READING LAMP AND PANEL TIME
The BE_Micro menu of the Service Menu displays the current lamp and
panel time of a set.
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote Commander within a
second of each other:
Channel 5
DISPLAY
One of the three Service Menu displays. (For more information
regarding the Service Menus, see
2-2. Accessing Service Adjustment Mode.)
3. Press JUMP until the BE-Mircro service menu displays.
CONFIGRATION
CP18_COLOR_SYS
4. To read the Lamp time, press 4 to display the GW_SPECIAL
category and the LAMP_TIME item.
GW_SPECIAL
LAMP_TIME
The screen displays:
"Total LAMP TIME is 14 hours"
5. To read the Panel time, press 4 to display the PANEL_TIME item.
GW_SPECIAL
PANEL_TIME
The screen displays:
"Total PANEL TIME is 14 hours"
6. Do one of the following:
a. If you have replaced the lamp, proceed to "Resetting the Lamp
Time".
b. If you have not replaced the lamp, turn off the set by pressing
POWER
KF-E42A10/E50A10
Volume + POWER .
00 SERVICE
00 00A0 BE Micro
34 SERVICE
02 00000014 BE Micro
34 SERVICE
01 00000014 BE Micro
RESETTING THE LAMP TIME
When replacing the lamp, use the following to reset the lamp time.
1. If the Self-Diagnostic screen is already displayed, proceed to step 4.
If not, Power off (Set to Standby mode).
2. Press DISPLAY
Channel 5
POWER
3. Press JUMP until the BE-Mircro service menu displays.
CONFIGRATION
CP18_COLOR_SYS
4. To access the Lamp reset, press 5 until the OPTION_E category
displays, and then press 1 until the LAMP item displays.
NOTE: If you pass the OPTION_E category, press 2 to go back
through the list.
OPTION_E
LAMP
5. To reset the Lamp time, press 3
write the change into memory.
WRITE is momentarily displayed
OPTION_E
LAMP
6. To verify the Lamp has been reset press 5 until the GW_SPECIAL
category displays, and then press 1 until the LAMP_TIME item
displays.
GW_SPECIAL
LAMP_TIME
The screen displays:
"Total LAMP TIME is 0 hours"
NOTE: You cannot reset the Panel time with the Service menu.
EXITING SERVICE MODE
After completing the changes, exit service mode by turning off the set
using the Remote Commander or the power switch.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.
KF-E42A10/E50A10
Sound Volume -
00 SERVICE
00 00A0 BE Micro
20 SERVICE
01 0014 BE Micro
ENT to
MUTING
20 WRITE
01 0014 BE Micro
34 SERVICE
02 00000000 BE Micro
13