Sony KF-E42A10 Service Manual page 42

C SHIELD ASSEMBLY (1 OF 3)
1
Install conductive Tape onto lower C-shield.
(tape p/n: 2-655-492-31)
Use lower edge of shield as guide for vertical alignment.
Use left side of metal tab as horizontal alignment guide.
3
Install C-Bd into Lower Metal Shield. Apply 3x8mm screws
and One clamp
Screw p/n:2-580-593-01; M3 Wire Holder p/n:2-594-860-01
5
nd
Apply 2 conductive tape to top of C-Bd.
KF-E42A10/E50A10
2
Fold excess tape over metal tab. Gasket tape must not hang over metal
tab (short circuit can happen).
4
nd
Install 2 conductive tape (p/n:2-655-492-31)
Use line of Jig lands as vertical alignment reference. Use edge
of lower shield cut-out as horizontal alignment reference.
6
Fold excess conductive tape over lower edge of C-Shield.
KF-E42A10/E50A10
Tool / Torque
-Phillips Screw Driver
-All screws 5kg-cm
+-0.5kg-cm
Caution Points
42