Sony KF-E42A10 Service Manual page 38

B BLOCK ASSEMBLY (2 OF 5)
5
Install thermal pads on B-Bd shield plate (p/n:2-632-927-02).
p/n: 2-633-208-01 (12x12mm) 2-places
p/n: 2-633-843-01 (19x19mm)
p/n: 2-586-500-01 (radiation sheet)
7
Install FFC Guard to bottom of DM Sheet Shield
p/n: 2-652-122-01.
CAUTION: Make sure FFC Guard "snaps" in place.
Push on all corners to ensure FFC Guard is properly
seated.
KF-E42A10/E50A10
6
Install B-Bd shield and B-Bd in DM Sheet Shield. Apply 3x8mm screws (4
places) p/n:2-580-593-01.
8
Install 49P FFC Cable (p/n:1-910-015-13) 2 places.
CAUTION: Cable is NOT installed in CN7302(QG-Bd)!
CAUTION2: Do not put excessive bends in cables
close to the PWB connector header. This is NG for EMI.
KF-E42A10/E50A10
Tool / Torque
-Phillips Screw Driver
- 5kg-cm +-0.5kg-cm
Caution Points
Please Follow All
CAUTION
points listed. It
is important to control
VARIATION of wire
routing for minimizing
Electro Maagnetic
Interference (EMI)
38