CHASSIS ASSEMBLY (3 OF 3)
9
Install AGA-Bd on GTA-Bd.
CAUTION: Make sure connector is completely
connected/locked. Make sure there is no gap
between mating parts.
KF-E42A10/E50A10
10
Install Conn. Assy. 1-910-015-17 Lighning ground to GTA-Bd
CN6011 CN6012.
Use 20x50mm himelon tape to hold insulation tube against AGU
shield (4-079-129-21).
CAUTION: Make sure wires are slightly higher than the top of
heat sinks adjacent to AGU shield. This is LOWER than on
TROY DIGITAL models.
10a
KF-E42A10/E50A10
Tool / Torque
-Phillips Screw Driver
-[3x12mm]
-7kg-cm +-0.5kg-cm
-[3x8mm]
- 5kg-cm +-0.5kg-cm
Caution Points
Please Follow All
CAUTION
points listed. It
is important to control
VARIATION of wire
routing for minimizing
Electro Maagnetic
Interference (EMI)
47