Table of Contents
Advertisement
The control panel
9-2-5
The Toggle and Loc/Rem Key
70
This key has two functions: Toggle and switching between Loc/
Rem function.
Press one second to use the toggle function.
Press and hold the toggle key for more than five seconds to
switch between Local and Remote function, depending on the settings in
[2171] and [2172].
When editing values, the toggle key can be used to change the sign of the
value, see section 9-5, page 75.
Toggle function
Using the toggle function makes it possible to easily step through selected
menus in a loop. The toggle loop can contain a maximum of ten menus. As
default the toggle loop contains the menus needed for Quick Setup. You can
use the toggle loop to create a quick-menu for the parameters that are most
importance to your specific application.
Note Do not keep the Toggle key pressed for more than five seconds without
pressing either the +, - or Esc key, as this may activate the Loc/Rem function
of this key instead. See menu [217].
Add a menu to the toggle loop
1. Go to the menu you want to add to the loop.
2. Press the Toggle key and keep it pressed while pressing the + key.
Delete a menu from the toggle loop
1. Go to the menu you want to delete using the toggle key.
2. Press the Toggle key and keep it pressed while pressing the - key.
Delete all menus from the toggle loop
1. Press the Toggle key and keep it pressed while pressing the Esc key.
2. Confirm with Enter.
Default toggle loop
Fig. 57 shows the default toggle loop. This loop contains the necessary
menus that need to be set before starting. Press Toggle to enter menu [211]
then use the Next key to enter the sub menus [212] to [21A] and enter the
parameters. When you press the Toggle key again, menu [221] is displayed.
Section 9-2
Advertisement
Table of Contents
