Function Keys - Omron SX-F Instruction Manual

The control panel
9-2-6

Function keys

Table 22 Function keys
ENTER key:
ESCAPE key:
PREVIOUS key:
NEXT key:
- key:
+ key:
72
Remote mode
When the VSD is switched to REMOTE operation, the VSD will be controlled
according to selected control methods in the menu's Reference Control [214],
Run/Stop Control [215] and Reset Control [216].
To monitor the actual Local or Remote status of the VSD control, a "Loc/Rem"
function is available on the Digital Outputs or Relays. When the VSD is set to
Local, the signal on the DigOut or Relay will be active high, in Remote the sig-
nal will be inactive low. See menu Digital Outputs [540] and Relays [550].
The function keys operate the menus and are also used for programming and
read-outs of all the menu settings.
-Step to a lower menu level
-Confirm a changed setting
-Step to a higher menu level
-Ignore a changed setting, without confirming
-Step to a previous menu within the same level
-Go to more significant digit in edit mode
-Step to a next menu within the same level
-Go to less significant digit in edit mode
-Decrease a value
-Change a selection
-Increase a value
-Change a selection
Fig. 58 Menu structure
Section 9-2