Table of Contents
Advertisement
Main Setup [200]
11-2-1 Operation [210]
Selections concerning the used motor, VSD mode, control signals and serial
communication are described in this submenu and is used to set the VSD up
for the application.
Language [211]
Select the language used on the LC Display. Once the language is set, this
selection will not be affected by the Load Default command.
Default:
English
0
Svenska
1
Nederlands
2
Deutsch
3
Français
4
Español
5
Russian
6
Italiano
7
Cesky
8
Turkish
9
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
Select Motor [212]
This menu is used if you have more than one motor in your application. Select
the motor to define. It is possible to define up to four different motors, M1 to
M4, in the VSD. For parameter set handling including Motor sets M1-M4 see
Chapter 11.2.6.
Default:
M1
0
M2
1
M3
2
M4
3
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
211 Language
Stp
English
A
English
English selected
Swedish selected
Dutch selected
German selected
French selected
Spanish selected
Russian selected
Italian selected
Czech selected
Turkish selected
43011
168/170
4bc3
UInt
UInt
212
Select Motor
Stp
A
M1
Motor Data is connected to selected motor.
43012
168/171
4bc4
UInt
UInt
Section 11-2
M1
85
Advertisement
Table of Contents
