Trip Autoreset/Trip Conditions [250] - Omron SX-F Instruction Manual

High power direct torque control inverters
Table of Contents

Advertisement

Main Setup [200]

11-2-7 Trip Autoreset/Trip Conditions [250]

106
Fieldbus format
Modbus format
Note The actual value of menu [310] will not be copied into control panel memory set.
Load Settings from Control Panel [245]
This function can load all four parameter sets from the control panel to the
VSD. Parameter sets from the source VSD are copied to all parameter sets in
the target VSD, i.e. A to A, B to B, C to C and D to D.
Start commands will be ignored during loading.
Default:
No Copy
A
B
C
D
ABCD
A+Mot
B+Mot
C+Mot
D+Mot
ABCD+Mot
M1
M2
M3
M4
M1M2M3M4
All
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
Note Loading from the control panel will not affect the value in menu [310].
The benefit of this feature is that occasional trips that do not affect the process
will be automatically reset. Only when the failure keeps on coming back,
recurring at defined times and therefore cannot be solved by the VSD, will the
unit give an alarm to inform the operator that attention is required.
For all trip functions that can be activated by the user you can select to control
the motor down to zero speed according to set deceleration ramp to avoid
water hammer.
Also see section 12-2, page 261.
UInt
UInt
245 Load from CP
Stp
No Copy
A
No Copy
0
Nothing will be loaded.
1
Data from parameter set A is loaded.
2
Data from parameter set B is loaded.
3
Data from parameter set C is loaded.
4
Data from parameter set D is loaded.
5
Data from parameter sets A, B, C and D are loaded.
6
Parameter set A and Motor data are loaded.
7
Parameter set B and Motor data are loaded.
8
Parameter set C and Motor data are loaded.
9
Parameter set D and Motor data are loaded.
10
Parameter sets A, B, C, D and Motor data are loaded.
11
Data from motor 1 is loaded.
12
Data from motor 2 is loaded.
13
Data from motor 3 is loaded.
14
Data from motor 4 is loaded.
15
Data from motor 1, 2, 3 and 4 are loaded.
16
All data is loaded from the control panel.
43025
168/184
4bd1
UInt
UInt
Section 11-2

Advertisement

Table of Contents
loading

Table of Contents