Bajaj Dominar 400 Service Manual page 30

1
Leo y Aprendo
Table Maintenance and Lubrication
Checkpoints periodic
Nº
maintenance
Clean the vehicle with water and dry
1.
thoroughly.
2. Engine oil and oil filter
Strainer oil & strainer evacuation
3.
4. Spark Plug
5. Air Filter
6. Fuel Filter
7. Fuel Lines
8. Valves
Cleaning and lubrication of sealed
9.
drive chain
10. Air Filter Drain Tube
11. Clean drain hole muffler
Cleaning chamber end of the tail pipe of
12.
the muffler
13. Pivot pin brake pedal
brake pad - Check wear indicator
14.
Brake fluid level - Fill / Replace
15.
Brake disc assembly - Check operation,
16.
leakage or other damage
17. Set free all cables
Cable harness, battery connections
18. -addressing, setting bands and braces
19. Turn Indicators
Cleaning the ignition and contact switches
20. controls
Bearing steering stem and the bearing
21.
cover (plastic)
22. Side door latch
23. Adjusting all fasteners
Bajaj Auto International Business
26
Recommended frequency
Service 1st 2nd 3rd
450 - 2450- 4950-
Km
500 2500 5000
3 3 3
Rv, Re Re Re Re
Lm Lm Lm Lm
Lm,Rv,
Lm,Rg
Rg
Re
Re
Rv, Re
Rv, Rg
Lm, Lm, Lm, Lm,
Lb, Rg Lb, Rg Lb, Rg Lb, Rg
Lm
Lm Lm Lm
Lm Lm Lm
Rv,Lb,R Rv,Lb, Rv,Lb,
Rv
e Re Re
Rv, Re Rv, Re Rv, Re Rv, Re
Rv,Rll,R
e
Rv Rv Rv Rv
Rv, Rg Rv, Rg Rv, Rg Rv, Rg Rv, Rg Rv, Rg Rv, Rg Rv, Rg
Rv, Rv, Rv, Rv,
Rg, A Rg, A Rg, A Rg, A
Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A
Rv, Lm Rv, Lm Rv, Lm Rv, Lm Rv, Lm Rv, Lm Rv, Lm Rv, Lm
Rv,Lm, Rv,Lm, Rv,Lm, Rv,Lm,
Lb,Re Lb,Re Lb,Re Lb,Re
Lm, Lb Lm, Lb
Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A Rv, A
4th 5th 6th 7th
12450-
7450- 9950- 14950-
7500 10000 12500 15000
3 3 3 3
Re Re
Re Re
Lm Lm Lm Lm
Lm,Rg
Lm,Rg
Re
Re
Rv, Re
Rv, Rg
Lm, Lm, Lm, Lm,
Lb, Rg Lb, Rg Lb, Rg Lb, Rg
Lm
Lm Lm Lm Lm
Lm Lm Lm Lm
Rv,Lb, Rv,Lb, Rv,Lb, Rv,Lb,
Re Re Re Re
Re Rv, Re Rv, Re Re
Rv, Rll
Rv, Rll
Rv Rv Rv Rv
Rv, Rv, Rv, Rv,
Rg, A Rg, A Rg, A Rg, A
Rv,Lm, Rv,Lm, Rv,Lm, Rv,Lm,
Lb,Re Lb,Re Lb,Re Lb,Re
Lm, Lb Lm, Lb
Observations
Avoid getting water in the gas
tank,muffler and electrical parts.
When washing use a
non-caustic detergent.
SAE 10W50Synthetic
Clean screen when
perform oil change.
Check and adjust at 5000
km.Replace after 20,000 km
No need cleaning. Replace after
10,000km
Replace at 10 000 km
Replace if necessary
Check & Adjust at 10 000 km
The customer must apply chain
spray lubrication OKS every 500
km
Clean each10,000km
The end of the chamber must
be cleaned using a brush.
Use all recommended grease.
Replace shoes / pads every
15,000 km
Use brake fluid (DOT 4)
replace every 30,000 Km
Use spray WD40
Check and replace if
damaged. HP Lithon RR3
use grease to lubricate
Use all-purpose grease
recommended