Step Two: Configure The User Network Parameters - 3Com 3C421600A Management Manual

Step Two: Configure
the User Network
Parameters
Configure network user with the following commands:
set network user <name>
address_selection [specified | assign | negotiate]
remote_ip_address <ip address>
ip [enable | disable]
ipx [enable | disable]
appletalk [enable | disable]
bridging [enable | disable]
send_password <password>
default_route_option [enable|disable]
mtu <mtu size>
spoofing [enable|disable]
1 Specify the type of address selection and remote IP address.
set network user <name>
address_selection [specified | assign | negotiate]
remote_ip_address <ip address>
Table 20 address_selection parameter
Configurable Address Type
A specific remote IP address.
When configuring a remote IP address, the RAS 1500
automatically sets address selection to specified.
the RAS1500 to assign the remote link an IP address from
a locally defined address pool.
the RAS 1500 to automatically select the LAN address to
be negotiated by IPCP.
The remote_ip_address for a numbered link is the IP address of the
dial-up port on the remote device. The remote_ip_address for an
unnumbered link is the IP address associated with the unnumbered
interface on the remote device to which this link is being configured (for
example, the Ethernet port of the remote device).
Example:
set network user main_office address_selection specified
remote_ip_address 123.123.123.2
Configuring LAN-to-LAN Routing
Parameter
specified
assign
negotiate
99