Displaying System Information; List Commands; Show Commands - 3Com 3C421600A Management Manual

Displaying System
Information

List Commands

Show Commands

You can use list commands to view current configurations for all values
stored in tables as well as facilities, files (FLASH memory configuration),
and other data.
List Critical Events
The list critical events command displays the last ten critical
status events, and the system time when each occurred. You can change
which events are displayed on the console and syslogged over Telnet
sessions, using the set facility command, which is useful for
troubleshooting and debugging.
You can use show commands to view the current configuration and its
routing activity. A few of the show commands used for troubleshooting
are covered in this section, including show memory, show
connection settings, show connection counters, and
show accounting settings.
Show Memory
The show memory command displays the system DRAM memory
utilization.
Example:
SYSTEM MEMORY RESOURCES
Total System Memory Resources: 22387 KB
Free Memory:
Code Size:
Initialized Data Size:
Uninitialized Data Size:
Stack Size:
Show Dial-in Connection Settings and Counters
The show connection command summarizes settings and the number
of incoming calls for dial-in connections. You can reset default settings
with the set connection command.
show connection [settings] [counters]

Displaying System Information

3584 KB
2490 KB
0 KB
6080 KB
0 KB
173