3Com 3C421600A Management Manual page 215

10 Configure a Frame Relay PVC and associate a user with it.
add frame_relay pvc atob dlci 101 interface rm0/wan:1 user
siteb enabled yes
11 Save your work.
save all
Configuring the RAS 1500 for Site B:
If an IP network has been defined, configured, and enabled on the RAS
1500, steps 1 through 3 are not necessary.
1 Add an IP network.
add ip network siteb interface rm0/eth:1 address
172.17.253.254/b
2 Set the IP network routing protocol.
set ip network siteb routing_protocol ripv1
3 Enable the IP network.
enable ip network siteb
4 Add a user.
add user sitea type network network_service fr_1490 enabled
no
5 Set the user protocol settings.
set network user sitea ip enable ipx disable appletalk
disable bridging disable
6 Set the user remote IP address.
set network user sitea remote_ip_address 172.16.253.254/b
7 Set the user routing settings.
set network user sitea ip_routing both rip ripv1
8 Enable the user.
enable user sitea
9 Configure the Frame Relay datalink.
add datalink frame_relay interface rm0/wan:1 enabled yes
10 Configure a Frame Relay PVC and associate a user with it.
add frame_relay pvc btoa dlci 102 interface rm0/wan:1 user
sitea enabled yes
11 Save your work.
Case Study 213