Before You Begin; Basic Frame Relay Configuration Using The Command Line Interface; Frame Relay User Configuration - 3Com 3C421600A Management Manual

206 C 13: U
HAPTER SING

Before You Begin

Basic Frame Relay
Configuration
Using the
Command Line
Interface
Frame Relay User
Configuration
F R
RAME ELAY
Before you configure the RAS 1500 for Frame Relay you must determine
the following information:
LMI protocol used: Annex A, Annex D, or LMI
DLCIs of all PVCs on the Frame Relay network
CIR monitoring support
CIR of each PVC
Protocols supported over the Frame Relay line
Network addresses for the protocols routed over Frame Relay
Once you have obtained all required information, installed the RAS 1500,
and configured all required system level parameters, you are ready to
begin configuring the RAS 1500 to use Frame Relay.
There are three basic components to a Frame Relay configuration:
Frame Relay user
Frame Relay data link
PVC/User mappings
The parameters specified in these components define the physical Frame
Relay interface, the protocols to routed over Frame Relay and the
relationship between Frame Relay users and an individual PVC.
Use the following steps to configure a Frame Relay user:
1 Add a Frame Relay user.
add user <username> type network,dial_out network_service
fr_1490
2 Specify the user network parameters.
set network user <username> ip [enable | disable] ipx [enable
| disable] appletalk enable | disable] bridging disable