3Com 3C421600A Management Manual page 271

5 Configure the user routing parameters.
set network user branch_office ip_routing both rip ripv1
6 Add the PPP datalink.
add datalink ppp user <username> interface rm0/wan:1
Example:
add datalink ppp user test interface rm0/wan:1
7 Configure authentication.
set ppp receive_authentication pap
set system transmit_authentication_name main_office
8 Save your work.
save all
To configure the RAS 1500 in the Branch Office, perform the following:
If an IP network has been defined, configured, and enabled on the RAS
1500, steps 1 through 3 are not necessary.
1 Add an IP network.
add ip network ipnet-2 address 192.112.227.1/C interface
rm0/eth:1
2 Add a user.
add user main_office password boston type network,dial_out
set user main_office idle_timeout 300
3 Configure the user network parameters.
set network user main _office address_selection specified
remote_ip_address 78.0.0.1/A
set network user main _office ipx disable appletalk disable
bridging disable
set network user main _office send_password chicago
4 Configure the user dial-out parameters.
set dial_out user main _office local_ip_address 78.0.0.2/A
set dial_out user main _office site type ondemand
5 Configure the user routing parameters.
set network user main _office ip_routing both rip ripv1
PPP Over Serial WAN Port Case Study 269