3Com 3C421600A Management Manual page 79

4 Configure if RAS 1500 uses the asynchronous control character map to
filter incoming data. Use the following command:
set network user <name> ppp receive_acc_map [hex_number -
array of 4 bits]
Example:
set network user tom ppp receive_acc_map 0
5 Configure if RAS 1500 uses the asynchronous control character map to
filter outgoing data. Use the following command:
set network user <name> ppp transmit_acc_map [hex_number -
array of 4 bits]
Example:
set network user tom ppp transmit_acc_map 0
6 Configure how often PPP should examine packets to decide when to
renegotiate the optimum compression algorithm.
Table 16 PPP Packet Actions and Parameters
PPP Action
Renegotiate the entire PPP session if RAS 1500 does not
negotiate a PPP session
Examine every packet
Examine a packet every time PPP detects an error
Use the following command:
set network user <name> ppp reset_mode_co [auto |
every_packet | every_error]
Example:
set network user tom ppp reset_mode_co auto
7 Configure the ML-PPP channel values. Use the following commands:
set network user <name> ppp channel_decrement [0-100]
set network user <name> ppp channel_expansion [0-100]
set network user <name> ppp max_channels [0-8]
Example:
set network user tom ppp channel_decrement 20
set network user tom ppp channel_expansion 60
set network user tom ppp max_channels 1
8 Save your work.
Configuring RAS 1500
Parameter
auto
every_packet
every_error
77