For More Information; Analog V.34 Model: Fcc Part 68 Compliance Statement; Canadian Installations - 3Com 3C421600A Management Manual

280 A B: T
PPENDIX ECHNICAL SPECIFICATIONS

For More Information

Analog V.34 Model:
FCC Part 68
Compliance
Statement
Canadian
Installations
If these suggestions do not help, you might consult the following
booklet:
Interference to Home Electronic Entertainment Equipment Handbook
You can order the booklet from the U.S. Government Printing Office,
Washington, DC 20402. Ask for stock number 004-000-00498-1.
This equipment complies with Part 68 of the FCC rules concerning:
FCC Registration Number: labeled on the board
Facility Interface Code: 02LS2
Service Order Code: 9.OF
USOC Jack: RJ11C
REN: 0.4B
Equipment Jack: CA-A11
NOTICE: The Industry Canada label identifies certified equipment. This
certification means that the equipment meets telecommunications
network protective, operational and safety requirements as prescribed in
the appropriate Terminal Equipment Technical Requirements document(s).
The Department does not guarantee the equipment will operate to the
user's satisfaction. Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed
using an acceptable method of connection. The customer should be
aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative
designated by the supplier. Any repairs or alterations made by the user to
this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment. Users should ensure for their own protection that the
electrical ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.