3Com 3C421600A Management Manual page 31

3 Type the following:
config
The RAS 1500 displays information similar to the display below:
LAN A Configuration Information:
Network Address:
Hardware Type:
V2.30EC (880813)]
Hardware Setting:
The above example only has one frame type, so the network address is
0788.
4 Write down the network address for the frame type you will use.
Setting IPX Parameters
To configure the RAS 1500 LAN interface for an IPX network:
1 Specify IPX network information including the network name, address,
interface and frame type of the network segment connected to the RAS
1500 LAN port. The same physical network segment has a different
network number for each frame type used. Be sure to enter the network
number associated with the chosen frame type. Use the following
command:
add ipx network <network name>
address [ipx address]
interface rm0/eth:1
frame [dsap | ethernet_ii | novell_8023 | snap]
Example (abbr.):
add ipx network segment2 add 00000576 interface rm0/eth:1
frame ethernet_ ii
You can omit preceding zeros. The RAS 1500 accepts "576" as the
correct IPX network number.
2 Set the IPX default gateway with the format xxxxxxxx.xx:xx:xx:xx:xx:xx
where xxxxxxxx is the IPX network address and xx:xx:xx:xx:xx:xx is a MAC
address.
set ipx system default_gateway <network number.mac address>
Example:
set ipx system default_ gateway ABCD.011:11:01:11:00:11
To verify network settings, use the list networks command.
3 Save your work.
save all
[0788] [002608C0D53F4z]
[3Com 3C505 EtherLink Plus (Assy 2012 only)
IRQ=5, IO=300h, DMA 5
Configuration with the CLI 29