Dialing Out From A Network Computer; Case Study - 3Com 3C421600A Management Manual

Dialing Out From a
Network Computer

Case Study

1 From the Windows 95 or NT desktop, click Start, then Run. The Run
dialog box appears.
2 In the Open text box, enter the following:
telnet <ip address of the RAS 1500> <socket number>
Example:
telnet 192.112.227.115 6666
3 Click OK. The Telnet application is launched.
4 At the login prompt, type the user name, then press Enter.
5 At the password prompt, type the user password, then press Enter. The
RAS 1500 authenticates the user.
6 At the command prompt, issue AT commands to the modem.
This section provides a step-by-step example of configuring the RAS 1500
and network computers for Telnet dial-out.
A user on the network, Eddie, wants to dial out through the RAS 1500
using Telnet.
This example assumes the following:
Eddie uses a Windows 95 computer.
Analog I/O cards are installed in the RAS 1500.
All basic system and network configuration is complete.
To configure network dial-out service, follow these steps:
1 Access the RAS 1500 CLI.
2 Name the system "ras1500_north." Use the following command:
set system name ras1500_north
3 Specify an IP network named "ipnetwork" with an IP address of
149.112.152.195. Use the following command:
add ip network ipnetwork address 192.112.227.110
4 Add a modem group named "telnet_lan" that uses modems 1 and 2 on
slot 0. Use the following command:

Dialing Out From a Network Computer

67