Configure Client Workstations - 3Com 3C421600A Management Manual

54 C 4: C
HAPTER ONFIGURING
Configure Client
Workstations
D O /IP
IAL UT
Complete the following steps to install and configure DialOut/IP software
on each of the client workstations from which you plan to dial out.
Step 1: Install DialOut/IP Software
1 Insert the Resource CD into the workstation.
2 Navigate to the ClientSoftware\Dial-out\Tactical directory.
3 Double-click Setup.exe. After a few seconds, the readme file appears.
4 Review the readme file.
5 Close the NotePad application. The License Agreement dialog box
appears.
6 Review the license agreement, then click I Agree. The "Welcome" dialog
box appears.
7 Follow the instructions on the screen. After several steps, the "Installation
Completed" dialog box appears.
8 Click Finish. The Select Ports dialog box appears.
Step 2: Create DialOut/IP COM Ports
1 In the Select Ports dialog box, select the COM ports you want DialOut/IP
to create. The list does not include COM ports that are in use.
2 Click OK. The COM ports are created. A dialog box appears.
3 Click Reboot Now. The workstation reboots.
Step 3: Run the Configuration Wizard
1 After the workstation reboots, a DialOut/IP icon appears in the
lower-right corner of the Windows desktop.
2 Double-click the DialOut/IP icon. (To determine which icon is the
DialOut/IP icon, hold the mouse pointer over each icon until you see
"DialOut/IP..." in the pop-up window.) The Configuration dialog box
appears; a list of the COM ports you selected before the reboot is on the
left side of the dialog box.
3 In the list of COM ports, select the port you want to configure. You can
configure only one port at a time.
4 Click Configuration Wizard. The Configuration Wizard dialog box
appears.