Making A Wireless Connection - Toshiba SD-H400-S-TU Installation Manual

Making a Wireless Connection

Use this example if you have a home network that includes a wireless access point (WAP)
or wireless router.
To connect a wireless network adapter to your DVR:
1. Connect to the adapter. If it is not already attached, connect one end of the USB
cable that came with your wireless network adapter to the port located on the back of
the adapter.
2. Connect to the DVR. Connect the other end of the USB cable to the USB port on the
DVR. The power light on the wireless adapter may come on before the cable is
completely inserted into the USB slot. Make sure you push the cable all the way into
the USB slot.
3. Position the adapter. Position the adapter in an open location so that the signal is
easily transmitted. For example, if your DVR is in an entertainment center, you might
place the adapter on top of your entertainment center. Do not place the wireless
M a k i n g a W i r e l e s s C o n n e c t i o n
adapter.
The cable may already be attached
to your wireless network adapter.
®
You can leave your DVR plugged in
while you connect a network
®
7
83