Power Source; Fcc Information - Toshiba SD-H400-S-TU Installation Manual

Introduction-New.fm Page vi Monday, June 9, 2003 4:48 PM

Power Source

TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V
60Hz polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to other than the specified voltage (120V 60 Hz). Use the attached
power cord only.
• If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade.
It is the user's responsibility to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit from the AC outlet and plug it back in. The unit
should return to normal operation.

FCC Information

Federal Communication Commission (FCC) - This equipment complies with both Part 15 and Part 68 of the FCC rules.
This equipment has been tested and found to comply with the limits for a Class B digital device, persuant to part 15 of the FCC Rule. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
vi
P o w e r S o u r c e
AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other.)