Toshiba SD-H400-S-TU Installation Manual page 66

5Troubleshooting-New.fm Page 53 Monday, June 9, 2003 3:04 PM
• You may not have the correct input selected on your TV. Use the "Input," "Source,"
"Select," or "TV/Video" button on your TV's remote to change the input. If you are
passing the signal through your VCR (as in Setup 4 in this guide), you may need to
select the correct input on the VCR as well.
If you have a cable or satellite box and used the IR Control cable:
• Make sure the cable or satellite box is turned on.
• Make sure you are using the SD-H400's remote control, and that you hold it so that the
TiVo button points toward the SD-H400, not at the cable or satellite box.
• Refer to page 14 to verify that the IR Control cable is positioned correctly in front of
the IR sensor. Also, make sure that the purple end of the cable is plugged into the
Channel Change-IR connector on the back of the SD-H400.
• You may consider optimizing the IR Control connection as described on page 14.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 14 for more on choosing an IR code.
• Try using the cable or satellite box's remote to change the channel. If it doesn't work,
contact the manufacturer or service provider for assistance.
T r o u b l e s h o o t i n g
5
53