Advertisement
INTELLIGENT SERVER
Maintenance Space
Maintenance space is required for installation and maintenance of the unit.
4
Cable Connection
AC Power Cable Connection
REQUIREMENT
Power cable is not supplied for the Intelligent Server. Insert a three core power cord applicable to the
standard of the country you use. Be sure to connect the earth line of the power cable securely.
• Insert an AC power cable into the AC inlet of the unit.
• Connect the power cord plug to an outlet (120 V, AC).
REQUIREMENT
• Disconnect the appliance from the main power supply. Connect this appliance to the main power supply by a
circuit breaker or a switch with a contact separation of at least 0.118" (3 mm).
• Make sure that the outlet is earthed.
•
Ethernet wire Connection
• Insert the Ethernet wire into the Ethernet port1 (LAN1).
Serial Port (RS-485) Connection
• Confirm that the power supply for the Intelligent Server is shut off.
• Connect RS-485 cable (packaged with the Intelligent Server) to Serial port 1 (COM1).
Fix the cable to the Intelligent Server by the fixing screws (two locations on both sides) attached to the connector
on RS-485 cable.
9-EN
Rear
Unit : inch (mm)
INTELLIGENT
SERVER
Front
39.37" (1000)
39.37" (1000)
Maintenance space
:
Installation space
:
– 9 –
Installation Manual
Advertisement
