Toshiba SD-H400-S-TU Installation Manual page 64

5Troubleshooting-New.fm Page 51 Monday, June 9, 2003 3:04 PM
My SD-H400 remote control doesn't
control my TV's power, volume, etc.
My SD-H400 remote control doesn't
work with my SD-H400.
the Input, Source, or TV/Video button on your TV's remote to change the input (i.e.,
the video signal your TV is displaying).
• If you're using Composite Video and L/R Audio cables or S-Video cables , make sure
your TV is displaying the appropriate video source. You may need to use the "Input,"
"Source," "Select," or "TV/Video" button on your TV's remote to change video
sources. If you are having trouble changing the video source, refer to the instructions
that came with your TV.
• If you are passing the signal through your VCR (as in Setup 4 in this guide), tune your
TV the way you would to watch your VCR. Also, try turning your VCR on or off. If
your VCR has multiple inputs, you may need to select the correct input on the VCR as
well.
• If your SD-H400 is connected to an A/V receiver or switch box, and you are having
trouble finding the correct input, try connecting it directly to the TV instead.
• The cables you are using to connect your SD-H400 to your TV or other equipment
may be damaged or defective. Try exchanging the cables connected to the SD-H400
with other cables that you know are working properly.
• You must first program the SD-H400's remote control to turn your TV on and off and
control its volume and mute functions. You can also program it to control volume and
mute on an A/V receiver or stereo. For more information, see Chapter 4.
• Be sure that you are using the SD-H400's remote and that you hold it so that the TiVo
button points toward the SD-H400.
• Press any button on the remote. Make sure that the batteries are positioned correctly in
the remote. If they are correctly positioned, try a new set of batteries. See the remote
T r o u b l e s h o o t i n g
5
51