Toshiba SD-H400-S-TU Installation Manual page 45

4ProgrammingRemote-New.fm Page 32 Monday, June 9, 2003 3:02 PM
C h a p t e r 4
TV POWER
VOLUME
32
Performing a Code Search
If none of the codes listed allows you to control your device, a code search may detect the
correct code. Performing a code search can take up to 20 minutes.
TV/VIDEO
1. Prepare the remote control. Point the remote away from your DM Server and cover the
MUTE
front end with your hand.
Refer to the table below and determine which two buttons to press to prepare the
remote. Press and hold the buttons simultaneously for more than 5 seconds.
TV power, volume,
To Control:
and mute
TV and TiVo
Press the:
buttons
2. Enter the search code. Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
TV power, volume,
To Test:
and muting
0999
Enter:
3. Test the remote control. Point the remote control at the TV or A/V stereo system. Press
CHAN UP to test the first code. Did the TV or A/V stereo system turn off? If not, wait
two or three seconds, then press CHAN UP again. Continue doing this until the TV or
A/V stereo system responds.
When the TV or A/V receiver does turn off, press SELECT/ENTER to select the
current code.
Unfortunately, due to the great variety of TVs and A/V stereo systems, some makes
and models are not compatible with your DM Server's remote control. If you reach the
end of the available codes without finding a code that works with your device, you will
need to use your TV or A/V stereo system's remote to turn it on and off, and control
the volume.
S e t t i n g U p t h e R e m o t e
TV input A/V system power,
volume, and mute
TV/VIDEO and TV and TiVo
TiVo buttons buttons
TV input A/V system power,
volume, and mute
0999 1999
C o n t r o l
A/V system volume
and mute only
MUTE and TiVo
buttons
A/V system volume
and mute only
1999