Table of Contents
Advertisement
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
Fuel supply system, petrol engines - Edition 05.2019
– Fit connector -arrow- to left flange. Ensure connections are
secured properly by pulling.
– Note installation position of covers -arrows-.
The -arrows- on the covers point forwards.
A - Cover for fuel delivery unit
B - Cover for fuel gauge sender 2 - G169-
– Check whether there are signs of oxidation on the earth wire
of the connectors, remove if necessary.
– Check installation position of earth connection.
•
Ensure that connector -2- is seated securely on metal ring
-3-.
•
Contact -1- must be attached to fuel tank -4- and secured with
spacer bush -5-.
– Check the connection of the metal ring on the fuel filler neck
by measuring between the ring and a bare metal part of the
body using an ohmmeter.
•
Specification: approx. 0 ohm.
•
If the specification is not attained, there is a risk of explosion
due to electrostatic discharge.
WARNING
Risk of explosion of fuel tank caused by fuel pump activation.
Risk of severe injuries and burns.
– If a new or completely empty fuel tank has been installed, fill
it immediately with at least 5 litres of fuel.
Specified torque
♦
⇒ "1.1 Assembly overview - fuel tank", page 6
♦ ⇒ General body repairs, interior; Rep. gr. 72 ; Rear seat;
Removing and installing bench seat .
♦ ⇒ Propshaft and rear final drive; Rep. gr. 39 ; Removing and
installing propshaft .
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Removing and
installing wheel housing liner; Rear wheel housing liner .
40
Rep. gr.20 - Fuel supply system
Hide quick links:
Advertisement
Table of Contents
