Installing Suction-Jet Pump - Volkswagen CC 2012 Workshop Manual

– Disconnect connector to four-wheel drive control unit - J492-
-arrow-.
– Unclip sealing grommet -1- downwards from cover.
– Guide wiring harness of all-wheel drive control unit - J492- out
downwards.
– Remove cover -1- and release and separate connector
-arrow- from flange.
– Open locking ring using wrench - T10202- .
– Lift flange slightly and remove seal out of opening in fuel tank.
– Pull fuel gauge sender 2 - G169- upwards a little.
– Unclip locking lugs -arrows- of suction-jet pump.
– Pull suction-jet pump out from the side of the fuel gauge send‐
er 2 - G169- (left side of vehicle).
– Check that the fuel lines on suction-jet pump are fitted securely
and are not damaged.
– Additionally check suction-jet pump and fuel pump for any
soiling.

Installing suction-jet pump

Install in reverse order of removal. Please observe the following:
– Pull suction-jet pump through to the right side of the fuel gauge
sender 2 - G169- (left side of vehicle). If necessary, use a
guiding wire.
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
Fuel supply system, petrol engines - Edition 05.2019
109
8. Fuel pump