Table of Contents
Advertisement
Item
Status
Procedure
1.
Set the Community Name.
Set the community name of SNMP Agent installed in XDCAM.
Note
To perform communication with SNMP, the community name set in the SNMP manager should correspond to the
one set in XDCAM.
2.
Set the target hosts for the communication (Communication Hosts).
3.
Set the target hosts to which to send the trap (Trap Hosts).
Note
When you use SONY-PRO-MIB, select "specific" and then specify SNMP manager's IP address.
4.
Set the Authentication Trap.
5.
Save the setting by pressing "Execute".
Check that "OK" or "OK : Reboot the machine" is displayed in the Status field.
Note
The setting is effective after the power is turned on again.
To revert the setting, press "Reset".
SNMP Specification
The specifications of the stored SNMP Agent are shown below.
SNMP Version
SNMPv1
MIB definition
SMIv2
Support PDU
GetRequest, GetNextRequest, SetRequest, GetResponce, Trap
Standard MIB
MIB-2
Extended MIB
SONY-PRO-MIB, PROV1-XDCAMSTATION-MIB
System Configuration Examples
The system configuration examples and the corresponding settings are shown.
• Community Name
- Read-only Community: public
- Read-Write Community: private
- Trap Community: public
• Communication Hosts ": specific"
- IP Address 1: 192.168.0.1
- IP Address 2: 192.168.0.2
• Trap Hosts ": specific"
- IP Address 1: 192.168.0.1
- IP Address 2: 192.168.0.2
- IP Address 3: 192.168.0.3
PDW-HD1550
Setting
Function
Display only
OK, OK : Reboot the machine: Displayed when the data is saved
correctly
Note
When "NG" is displayed, check the entered characters
3-7
Advertisement
Table of Contents
