Table of Contents
Advertisement
4.
Perform the following procedure to check the COMPOSITE OUTPUT 2 (SUPER) connector output.
(1) Connect the COMPOSITE OUTPUT 2 (SUPER) connector to the analog composite waveform monitor as
shown below.
PMW
COMPOSITE
OUTPUT 2
(2) Check that level B of the white signal of COMPOSITE OUTPUT 2 (SUPER) output meets the specification.
If level B does not meet the specification, adjust it.
Note
"A20 : VPR VR" menu acts on both COMPOSITE OUTPUT 1 and COMPOSITE OUTPUT 2 (SUPER).
Make the adjustment so that both outputs meet the specification at the same time.
5.
Press the [F1 (RETURN)] button once to exit "A20 : VPR VR".
Saving the adjustment data
Perform the following procedure only when Output Level Adjustment is performed.
1.
Select "A2F : NV-RAM CONTROL" and execute "SAVE ALL ADJUST DATA".
Tip
• When data has been successfully saved, "Save Complete" appears in the menu screen.
• To load the pre-adjustment data without saving the adjustment data, execute "ALL DATA PREVIOUS".
2.
Exit the maintenance menu.
Termination
1.
Return "013: SYSTEM FREQUENCY SELECT MENU" setting to the customer's settings.
setup menu
ITEM-013 (SYSTEM FREQUENCY SELECT MENU)
2.
Re-set the setup menu and the function menu to the customer settings written down before adjustment. (Refer to
"Preparations")
PDW-HD1550
Composite
waveform monitor
75 Ω
mode
Customer setting
8-11
Advertisement
Table of Contents
