Table of Contents
Advertisement
4.
Remove the five screws to detach the heat sink.
Special head
(M2 x 2.7)
Heat sink
5.
Remove the DC fan (50 square).
(1) Disconnect the harness from the connector (CN500) on the BD-42 board.
(2) Peel the tape.
(3) Remove the two screws to detach the DC fan (50 square).
CN500
(BD-42 board)
Harness
Note
Install the DC fan (50 square) carefully paying attention to the label side and the harness position.
6.
Install the removed parts by reversing the steps of removal.
PDW-HD1550
Special head
(M2 x 2.7)
Tape
DC fan (50 square)
PSW3 x 12
Label
6-15
Advertisement
Table of Contents
