Table of Contents
Advertisement
14. Press the [→] button.
A confirmation window appears waiting for entry of the [PUSH SET] knob.
LENS CLEANING JIG
PLEASE CHECK
THE JIG IS SET.
CLEANING START?
OK: SET KEY
EXIT: MENU KEY
15. Press the [PUSH SET] knob.
The result is displayed.
LENS CLEANING JIG
FINISHED CLEANING
EXIT: MENU KEY
Note
If the cleaning resulted in a failure, the following message appears. In this case, turn off the unit and retry steps
from step 9.
LENS CLEANING JIG
ERROR
EXIT: MENU KEY
16. Press the [MENU] button several times to close the maintenance mode.
17. Turn off the unit.
18. Remove the lens cleaning base (4G).
When removing the lens cleaner from the lens cleaning base (4G), if the lens cleaner is pushed from the back of
the lens cleaning base (4G), the lens cleaning base (4G) may be damaged.
Hold the lens cleaner shaft with tweezers and remove the lens cleaner from the front of the lens cleaning base (4G).
19. Install the loader assembly, stay assembly and top plate assembly.
• Installing of loader assembly: Refer to
• Installing of stay assembly: Refer to
• Installing of top plate assembly: Refer to
Actions to be taken after cleaning
1.
Adjust the optical drive.
PDW-HD1550
"6-7-5. Loader
"6-7-1. Optical Drive
"6-3. Top Plate
("7. Adjustment of Optical Drive
Assembly".
Assembly".
Assembly".
System")
5-11
Advertisement
Table of Contents
