Table of Contents
Advertisement
7.
Install the removed parts by reversing the steps of removal.
Note
• After the work is completed, make skew adjustment. (Refer to
• Stick the heat gel at the location shown in the figure aligning it with the edge of IC700.
• Do not damage a heat gel.
• Do not place inclusion with the heat gel between the heat sink.
Align the heat gel with the edge of IC700.
BD-42 board
8.
Perform software settings using the menu after replacing/repairing the BD-42 board. (Refer to
Board")
PDW-HD1550
Heat gel
IC700
"7-4. SKEW
Adjustment")
"1-9-4. BD-42
6-35
Advertisement
Table of Contents
