Table of Contents
Advertisement
2.
Disconnect the harness from the connector (CN4) on the PS-885 board.
Harness
CN4
(PS-885 board)
Note
When connecting the harness, arrange the harnesses as shown in the figure.
3.
Remove the DC fan (30 square).
(1) Remove the two screws (PS2.6 x 5) to detach the DC fan (30 square) and the fan bracket.
(2) Open the clamp.
(3) Remove the two screws (PS2.6 x 16) to detach the DC fan (30 square).
PS2.6 x 16
DC fan (30 square)
Note
Install the DC fan (30 square) carefully paying attention to the label side and the harness position.
PDW-HD1550
Harness
Label
Fan bracket
DC fan (30 square)
Clamp
Harness
PS2.6 x 5
6-46
Advertisement
Table of Contents
