Figure 28 Wan > Internet Connection: Advanced Setup; Table 11 Wan > Internet Connection: Advanced Setup - ZyXEL Communications P-870HW-51a v2 User Manual

802.11bg wireless vdsl2 4-port gateway
Hide thumbs Also See for P-870HW-51a v2:
Table of Contents

Advertisement

Figure 28 WAN > Internet Connection: Advanced Setup
The following table describes the labels in this screen.
Table 11 WAN > Internet Connection: Advanced Setup
LABEL
RIP & Multicast
Setup
RIP Version
RIP
Operation
IGMP
Multicast
PPPoE
Passthrough
(PPPoE
encapsulation
only)
IP Filter
IP Filter
Active
VLAN
P-870HW-51a v2 User's Guide
DESCRIPTION
This section is not available when you configure the ZyXEL Device to be in bridge
mode.
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers.
This field is available only when you select ENET ENCAP.
This shows the RIP version used for this WAN connection.
This field is available only when you select ENET ENCAP.
This shows whether RIP is enabled (Active) or not (Disable) on this WAN
connection.
Multicast packets are sent to a group of computers on the LAN and are an
alternative to unicast packets (packets sent to one computer) and broadcast
packets (packets sent to every computer).
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group.
version 1 and version 2. Select Enable to turn on IGMP. Otherwise, select Disable.
This field is available when you select PPPoE encapsulation.
In addition to the ZyXEL Device's built-in PPPoE client, you can enable PPPoE
pass through to allow up to ten hosts on the LAN to use PPPoE client software on
their computers to connect to the ISP via the ZyXEL Device. Each host can have a
separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
This section is not available when you configure the ZyXEL Device to be in bridge
mode.
Select this option to enable IP filtering on this connection.
Chapter 5 WAN Setup
The ZyXEL Device supports both IGMP
57

Advertisement

Table of Contents
loading

Table of Contents