Figure 410 Example Xmodem Upload; Figure 411 Menu 24.7.2 As Seen Using The Console Port; Uploading Configuration File Via Console Port - ZyXEL Communications ZyWALL 2 Plus User Manual

Chapter 41 Firmware and Configuration File Maintenance

Figure 410 Example Xmodem Upload

After the firmware upload process has completed, the ZyWALL will automatically restart.

41.5.10 Uploading Configuration File Via Console Port

1 Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu
24.7.2 - System Maintenance - Upload System Configuration File. Follow the
instructions as shown in the next screen.

Figure 411 Menu 24.7.2 As Seen Using the Console Port

Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change when it is
restarted; please adjust your terminal's speed accordingly. The password
may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to "1234".
2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.
3 Enter "atgo" to restart the ZyWALL.
584
Xmodem upload on your terminal.
the system.
Do You Wish To Proceed:(Y/N)
ZyWALL 2 Plus User's Guide