Figure 262 Advanced > Remote Mgmt > Snmp; Table 125 Advanced > Remote Mgmt > Snmp - ZyXEL Communications ZyWALL 2 Plus User Manual

Chapter 21 Remote Management
Figure 262 ADVANCED > REMOTE MGMT > SNMP
The following table describes the labels in this screen.
Table 125 ADVANCED > REMOTE MGMT > SNMP
LABEL
SNMP
Configuration
Get Community
Set Community
Trap
Community
Destination
SNMP
Service Port
Service Access
Secure Client IP
Address
Apply
Reset
394
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows all
requests.
Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using
this service.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings.
Click Reset to begin configuring this screen afresh.
ZyWALL 2 Plus User's Guide